PRELIMINARY OPERATIONS

- clean the surfaces to be measured

- clean the feeler gauge, especially the sphere and the measuring tip

- bring the ball closer to the tip so that it touches the flat part with the sensor (zero value)

- hold the tip with the ball in a vertical position

- turn on the feeler gauge by connecting the power cord

-Wait for the end of the initial calibration

-Perform some empty measurements  you will notice a flashing W which indicates Wait (wait) and after a few flashes an @ appears which indicates that it is  calibrated.

-For a more accurate measurement, work at room temperature, carry out some empty measurements on a thickness of ~ 10 mm and wait at least 5 minutes.

​

​

MEASUREMENT

-Position the sphere on the surface  to be measured, while on the opposite surface in correspondence with the sphere, position the tip

- by means of magnetism the sphere is attracted to the tip without the need to force

- read the detected quota

- extract the sphere from the piece under examination

-Turn off the SpeXor by unplugging the power cord.

-After taking the measurement and without moving the tip, it is possible to reset (0.00) the value detected by pressing the button and the subsequent measurement will detect the difference between the first and second measurement (positive or negative with sign –_cc781905-5cde -3194-bb3b-136bad5cf58d_ before the value).

​

​

       ATTENTION! the force of magnetic attraction between the tip and the ball may not be sufficient to prevent the latter from falling, PAY ATTENTION!

​